Prefab house is widely using in the different industry: the temporary house for road, railway and building site, etc.Also can be as temporary office, meeting room , headquarters , public accommodation , and temporary store , school, hospital , parking lots, show rooms, electric house , repairing shop , gas station etc.
Why Choose Light Gauge Steel Structure?
1)Lifetime for structure: 30-60years.
2)Earthquake resistance: mix more than 8 grades.
3)Wind resistance:max 60m/s.
4)Fire resistance:all the materials used can be fire resistance.
5)Snow resistance:max 2.9KN/m²as required.
6)Heat insulation:100 mm in thickness can match 1 m thickness of brick wall.
7)High acoustic insulation:60db of exterior wall 40db of interior wall.
8)Insect prevention: Free from the damages by insects, such as white ants.
9)Ventilation:a combination of natural ventilation or air supply keep the indoor air fresh and clean.
10)Packing and delivery: 140SQM/ 40'HQ container for structure only and 90SQM/ 40'HQ container for structure with decorate materials.
11)Installation:the average is one worker one day install one SQM.
12)Installation guide:dispatch engineer to guide on site.
Types of prefab house we can fabricate:
a small stand alone building with insulation and electrical connections used as a dedicated office space - similar to studios, summer houses and garden rooms.
They are usually transported by tractor-trailers over public roads to sites which are often in rural areas or high-density developments. Often used for temporary accommodation on campsites. While these homes are usually placed in one location and left there permanently, they do retain the ability to be moved as this is a requirement in many areas.
other than a residential building, including any building constructed for industrial or commercial use. Types can include office buildings, warehouses, or retail.
Installation of SIPs Prefab house:
SIPs construction relies on careful planning and design prior to delivery and site assembly. A completely customized panel layout will be produced, in which all the panels are in numerical order with specific location.
Panels are shipped to the jobsite for assembly when the foundation and deck are in place. After the bottom plate is attached to the perimeter, placement of the wall panels begins. Panels weigh approximately three pounds per square foot, so 4' panels are light enough to be carried and set by hand. Exterior walls for most houses can be erected in less than a day. Nails and adhesive foam are used to fasten the panels to top and bottom plates, and to make vertical connections. Gutter spikes or long screws are often used for SIP corner connections. Walls must be properly braced and plumbed, and interior walls are typically constructed with conventional framing. Beams that carry roof loads may require stud supports incorporated into wall panels, to carry point loads downward. Heavier roof panels are usually set in place with a crane.
To take full advantage of SIPs insulating capacity, care must be taken to seal all joints properly, but the relatively small number of connections makes this easier to accomplish. Spray polyurethane foam is often used to fill any voids or gaps, joints and details.